Advances in Bamboo Science Vol. 9, 2024, 100100. Access >>
M. Seixas; D. Cardoso; L.E. Moreira; S. Paciornik
Abstract: Ultralight bamboo structures with flexible joints comprise a novel construction system that can meet the global demand for sustainable buildings, such as multi-use pavilions and temporary structures for disaster relief and humanitarian purposes. In this work, modular self-supporting space frames were designed, fabricated, and experimentally analyzed using bamboo culms, textile ropes, and biocomposite rings. Numerical models and a 1:3 scale prototype were used to investigate the structural response under sustained loadings. The mean values of 5.4 GPa for Young's modulus (E), a specific gravity (G) of 8 kN/m³ , and a Poisson's coefficient (ν) of 0.3 were adopted for the bamboo members. The prototype, constructed with two modular space frames, was tested under both symmetric and asymmetric loading conditions during 43-day static tests. A pronounced nonlinear behavior was observed for the symmetric loading of 4.8 kN and the asymmetric loading of 3.5 kN, whereas failure occurred at a total load of 6.5 kN for the asymmetric configuration, 7.5 times the prototype's self-weight. The observed failure of bamboo members was governed by crushing under bending, followed by local buckling of the upper rafters below the load application points. The experimental results were compared with numerical models to determine an effective modeling strategy for reproducing the actual structural behavior. A comparison revealed that the eccentricity of members at the joints must be considered for a reliable prediction and that creep can be accounted for through appropriate reductions in the modulus of elasticity. The observed differences are attributed to the sliding of members at joints under higher loads and due to local second-order effects. This study investigates the influence of elastic properties and nodes on the flexural behaviour of bamboo culms by comparing different characterization techniques and theoretical approaches. The most representative parts of the bamboo culm were selected using microscopic images of bamboo cross-sections. These were sliced from the bottom, middle, and top parts of a single culm and were analyzed with Digital Image Processing. Four-point bending tests were conducted on twelve culms of Phyllostachys aurea, subdivided into groups of untreated (UN) and heat-treated (HT) samples. The axial modulus of elasticity (Eb) and the shear modulus (G) were determined experimentally using four different mathematical models: (i) a global deflection model using the Euler-Bernoulli beam theory according to the ISO Standard; (ii) a global deflection model using the Timoshenko beam theory; (iii) a global deflection model based on the Timoshenko beam theory but accounting for the presence of nodes; and finally, (iv) a local model using extensometry. The dominant failure modes for UN and HT samples are described and discussed, and were influenced by the moisture content (MC). Approaches (i) and (ii) showed good agreement, giving reliable parameters to assess Eb. The third approach (iii) indicated that the nodes significantly influence the flexural behaviour of the culms. Approach (iv) was appropriate for determining G, but resulted in higher values of Eb, typically not representative of the material.
